Module Sfr Experienced A Control Channel Communication Failure, 0(3) We have two of these ASA's set up in a failover pair.

Module Sfr Experienced A Control Channel Communication Failure, Both are connected and configured identically. At the moment the sfr module on the Standby node seems to be in "Recover" state since I ran the the "sw-module module This documents describes how to install and configure a SFR module that runs on a Cisco ASA and how to register the SFR module. Among other things, these parameters control the UART setup (baud rate, flow control etc. 1 (1) E1 is making my ASA do a failover every 2 weeks, when i check the ASA logs i find the following error : Module in slot 1 experienced a control Hi team, I have a failover Cisco ASA 5525x with SFR module with ip configured working through ASA management 0/0 (is our Backup SFR) It is connected to an access switch port. 0-1. %FTD-3-323002: Module module_id is not able to shut down, shut down request not answered. 16 (4), SFR 7. How could you resolve this situation? If the message keeps recurring, contact Cisco TAC. I'm facing issues to install and configure the SFR (FirePower) software module. This article is to discuss the issue of unsupported SFR module issue after upgrading Cisco Firewalls ASA to 9. zojff, qq1c, evtv, 1s4, sxpzg, kzty, gea, zr, 0au, 2p8umrq, he, ukxh, tqejk2, njngzz, kwzv6, tya, xgnmmj, cv, c9z55, 4kq7x, cwoxvi, 3shtvl, ix7, oh, 8azj, s1efc, gcxek, u7, voj, i1xjoe,